Proteus Delta Staff, User Manual

Page: 7 / 23

the other side.
o The Delta is turned on and enters standby mode immediately
following the boot sequence which begins as soon as the
batteries have been inserted into the battery compartments.
o When you’re ready to power down the Delta, remove one of
the batteries one at a time before replacing the end cap and
moving on to the second battery.
o For storage, we recommend that the batteries be put back in
to the green battery bag or that you reverse BOTH batteries
inside of the battery compartments. (Positive end out,
Negative end in.) (Figure 2A)
Note: Failure to flip both batteries will cause the full discharge of the unflipped
battery. Afterwards, the battery will be unable to take a charge and will need to
be replaced. Over Discharge is not covered by the warranty.
●
Shell
o The shell of the Delta is made of a clear-blue, UV resistant
plastic. Proteus Kinetics takes pride in the durability of its
props and because of this, we carefully choose the materials
to maximize their toughness.
o That said, the Delta, LightSword and Delta are all vulnerable
to heat warping. Leaving your Delta in a hot car or in the sun
while resting on an uneven surface may cause warping which
Figure 2A
ProteusKinetics.com
Info@ProteusKinetics.com
856-437-0046
Strive.Adapt.
​
Shine
​
.