Protekt AT-014-2, Instruction Manual, Page: 6 / 24

6/24
Main
tripod
Beam
Main
tripod
Chain
T-lock T-lock
Trolley
Spirit level
For safety trolleys SHOULD BE always
positioned.
Always use T-lock's to lock trolley's
position during operation.
INSTALLING FULL HEXAPOD SET
1. Set both main tripods according to above instructions without chain. Legs should be pulled out and lock with the locking pin in
the position suitable for beam installation.
2. Set the both main tripods beam sockets facing to each other.
3. Place ends of the beam to the main tripod's beam sockets and lock with the locking pins.
4. Make sure the feet are on firm ground and can support the load.
5. The hexapod should be positioned over opening so working line will be located approximately in the center of the opening.
6. Secure the hexapod legs with the chain against the accidental sliding open. The ends of the chain must be fastened with a snap
hook. The chain should be tight between the legs of the hexapod.
LEVELING HEXAPOD BEAM / LOCKING TROLLEYS POSITION WITH T-LOCKS
Always ensure that the beam is true and level using mounted spirit level before use. Improper leveling may result in self
displacement the load being lifted along the beam which can cause injury to the operator.
WORKING LOAD LIMIT
: 1000 KG
WORKING LOAD LIMIT: 1000 KG
WORKING LO