Fig. 14
Fig. 15
Fig. 17
Fig. 18
Fig. 19
7
Meko manuale 1_2011
Click
Click
Once the assembling of the limit brackets to rack is completed, open and close the gate manually to check that the
brackets always activate the limit-switch system before the gate reach its mechanical stops. This checking is important to
preserve the correct working of the automation and continued good mechanical condition of the gate..
RIGHT motor
OPENING limit-switch
LEFT motor
CLOSING limit-switch
4. ELECTRICAL WIRING
Insert the electrical cables into the control panel’s case by
piercing the rubber membrane and place the cable grommet
in its purpose fabricated seat on the motor’s base (Fig. 17).
Terminate the cable of the main supply with the provided
cable block (Fig. 18). Follow the control panel’s instruction
manual to proceed with the correct cable wiring.
Wire all cables for the earth system to the provided lug and fix
onto the motor base point marked with symbol.
5. START-UP
Power the system and proceed with a careful checking of the
gear motor working and of all the accessories and safety devices
connected to the system.
In particular make sure that the electric limit-switch is always
activated in opening and closing before the gate reaches its
mechanical stops. Place the two slot-covers on the M10 screws.
Lift the motor cover down and close it with the two side screws.
(Fig. 19).
Hand over this instructions manual to the end user and demonstrate
the correct use of the automation and how to release the motor
for manual operation of the gate in the event of power cuts.
