14
DK
GB
DE
FI
FR
NL
SE
ES
IT
Product lifetime
The product’s expected lifetime is five years.
The product’s lifetime is based on correct use, cleaning, washing, service and maintenance.
Products that are used in excess of the above lifetime must be assessed for future use. The user
is responsible for continuously assessing whether the product can be used in excess of the lifetime
stated.
Cleaning
It is recommended to clean and wash the covers as the Protac SenSit
®
chair may become dirty
over time. The need and frequency of washing depend on the use of the chair.
Follow the instructions below when washing and cleaning the chair.
• The cover can be washed in a washing machine, min. 7 kg, using a detergent without
bleach and perfume. Fabric softener must not be used. See the washing instructions inside
the cover.
• The seat cover with incontinence fabric on the reverse side, can be unzipped and washed
separately using a detergent without bleach and perfume. Fabric softener must not be used.
See the washing instructions inside the cover.
• Neck and side wings can be washed in a washing machine, min. 7 kg, using the supplied
washing bags. Use detergent without bleach and perfume. Fabric softener must not be
used. See the washing instructions inside the wings.
Instructions before wash:
1. Take the neck pillow out of the neck compartment.
2. Seat zips off.
3. Loosen the inner shell with balls using the back Velcro.
4. Unzip the components with front and back foam plates.
5. Remove the ballbags from both neck wings (two bags).
6. Remove the inner shell.
7. Remove the back foam plate.
8. Remove the front foam plate.
9. Remove the ball bags from the side wings (two bags). The balls are washable, use the
enclosed laundry bag.
10. All zippers should be zipped up before the chair cover is washed.
Assembly after wash:
1. Unzip the seat cover.
2. Spread out the chair cover so Velcro on the inside of the bottom of the cover is visible.
3. Unzip the front foam cushion compartment.
4. Place the foam cushion in the compartment. Fold in both sides of the cushion when fitting
– it can be smoothed out again once it is in place.
5. Zip the compartment.
6. Unzip the compartment for the rear foam cushion.
7. Place the foam cushion in the compartment – remember the hard plastic side must face
inwards. Again, fold both sides of the foam cushion to ease placement.
8. Zip the compartment.
9. Position the inner bag in the cover so that the Velcro tapes meet at bottom and back.
10. Zip the seat cover. Remember to affix the Velcro on seat cover to the Velcro on the inner
bag (in the centre, close to the rear bag).
