P. 4
User Guide
CT-3360
To enable Idle Mode, press and hold the
LOCK
,
UNLOCK
or
START/STOP
button on your remote
transmitter while the engine is running.
Note:
When enabling Idle Mode, pressing
LOCK
or
UNLOCK
will automatically unlock the
doors.
The parking lights will come
O N
. Remove the key, exit the vehicle and lock the doors (if
desired). Pressing the
TRUNK
button at this point will lock all Doors and activate Idle Mode.
The engine will continue running and will turn itself
OFF
when the pre-programmed run time
expires (see Step 6 of the “
Setting the system to Ready Mode
” section on p. 2).
Valet Mode
Ignition Valet
The system can be placed in Valet Mode to disable the remote starting capabilities. If the
vehicle needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine
from being accidentally started by remote control.
To ENTER Valet Mode
1.
With the key in the Ignition switch, turn the key to the
ON (RUN/IGNITION)
and then
OFF
positions 5 times within 10 seconds.
2.
The Parking Light will flash 3 times indicating the Module is now in Valet Mode.
The LED will turn
ON
solid.
To EXIT Valet Mode
1.
With the key in the Ignition switch, turn the key to the
ON (RUN/IGNITION)
and then
OFF
positions 5 times within 10 seconds.
2.
The Parking Light will flash twice indicating the Module is now out of Valet Mode.
The LED will turn
OFF
.
Valet Mode using the Valet Button
(If installed)
To put the system
into
Valet Mode:
1.
Turn the key to the
IGNITION ON (RUN)
position.
2.
Press (for at least 1 second) and release the Valet Button. The L.E.D. will come
O N
.
To take the system
out of
Valet Mode:
1.
Turn the key to the
IGNITION ON (RUN)
position.
2.
Press (for at least 1 second) and release the Valet Button. The L.E.D. will go
OUT
.
The Valet button can only be used if the vehicle keys are in the
IGNITION ON (RUN)
position.
Panic Mode
Note:
Panic mode can only be activated if the horn has been adequately configured
by your installer.
In an emergency situation, you can activate Panic Mode using the
LOCK
or
UNLOCK
button.
This will:
•
shut down the engine,
•
unlock the doors (with the
UNLOCK
button)
•
or lock the doors (with the
LOCK
button),
•
disarm the Starter Kill and
•
activate the horn for 30 sec.
Note:
See the description of the
Starter Kill
option later in this Guide.
To activate Panic Mode:
•
Press and hold the
UNLOCK
button for approximately 3 sec. until the sound signal starts
and the parking lights flash: this will unlock the doors before the sound signal starts.
