background image

 

CT-3360 

User Guide 

P. 5

 

 

Or 

press and hold the 

LOCK

 button for approximately 3 seconds until the sound signal 

starts and the parking lights flash: this will lock the doors before the sound signal 
starts. 

Panic Mode will automatically shut down after 30 sec. 

Note: 

To stop Panic Mode before the end of its delay, press the 

LOCK

 or 

UNLOCK

 button 

until the sound signal stops. 

Cold Weather Mode 

When Cold Weather Mode is active, the engine starts every 2 hours and runs for 4 minutes 

(or for 20 minutes with Diesel engines); the routine goes on for a period of 24 hours. 

To 

enter 

Cold Weather Mode: 

 

With the vehicle already in Ready Mode, press and hold the 

START/STOP

 button until 

the parking lights flash 3 times. 

To 

exit 

Cold Weather Mode, do any one of the following: 

 

Open the hood. 

 

Start the engine using the remote control. 

 

Turn the ignition key to the

 IGNITION ON (RUN) 

position. 

 

Press and hold the 

START/STOP

 button for 3 seconds 

(until the parking Lights flash once) 

 

Set the vehicle to Valet Mode. 

Advanced Features 

Remote Door Locks 

If your system  was installed with the Remote Door Locks option, you will have the 

convenience of remote keyless entry. 

To  LOCK  your doors and  arm  the Starter Kill: 

1.

 

Press and hold the 

LOCK

 button for approx. 1 sec. 

2.

 

The parking lights will flash once and the L.E.D. will flash slowly to confirm that the 

doors have been locked and that the Starter Kill feature is enabled if it was installed. 

To  UNLOCK  your doors and  DISARM  the Starter Kill: 

1.

 

Press and hold the 

UNLOCK

 button for approx. 1 sec. 

2.

 

The parking lights will flash twice and the L.E.D. will go out to confirm that the doors 

have been unlocked and that the Starter Kill feature is disarmed if it was installed. 

Note: 

If installed and configured in Passive Mode at installation, the Starter Kill feature will 

rearm automatically 60 seconds after the doors are unlocked. For that reason, you may 

have to unlock your doors a second time if some time elapses before you actually start 

the engine. 

Arming the Starter Kill 

If installed, the Starter Kill can be programmed to arm in Active Mode (will not arm 

automatically) or in Passive Mode (will arm automatically). 

 

To 

disarm 

the Starter Kill in Active or Passive Mode, press the 

UNLOCK

 button on the trans-

mitter. The parking lights will flash twice. (If Remote Door Locks were installed, this will 

also unlock the doors.)  In Passive Mode, the system will automatically rearm 1 or 3 

minutes after the doors were unlocked. 

 

To 

arm 

the Starter Kill in Active or Passive Mode, press and hold  the 

LOCK

 button on the 

transmitter. The parking lights will flash once. (If Remote Door Locks were installed, this 

will also lock the doors). In Passive Mode, the system will automatically arm 1 or 3 minutes 

after the engine is shut down. 

Summary of Contents for ProStart CT-3360








Reviews: