ILX34-MBS
User Manual
Installing the Adapter
ProSoft Technology, Inc.
Page 5 of 29
2
Installing the Adapter
2.1
Installing the Mounting Base/Wiring Base Assembly
The wiring base assembly consists of a mounting base and a removable terminal block.
You can install the assembly or just the mounting base. Perform the following to install
the base/wiring base assembly:
1
Position the mounting base/wiring base assembly vertically above the installed
units (adapter, power supply, or existing module).
2
Slide the mounting base down allowing the interlocking side pieces to engage the
adjacent module or adapter.
3
Press firmly to seat the mounting base on the DIN Rail. The mounting base
snaps into place.
4
To remove the mounting base from the DIN rail, remove any installed module
(and any module immediately to the right) and use a small blade screwdriver to
rotate the DIN rail locking screw to a vertical position. This releases the locking
mechanism. Lift straight up to remove the mounting base.
5
Repeat this procedure for the next mounting base assembly.
