AN-X-MOD (Master) Page
55
Possible status values are:
Value
Meaning
1
Boot mode
2
Configuration mode
4
Production mode
Read Kernel Parameters
The
Utilities/Read Kernel Parameters
command displays various
communications parameters for the currently selected AN-X
This command resets the AN-X. You will be warned and given the
opportunity to cancel the command.
The
Utilities/Read Kernel Parameters
command leaves the AN-X
running the boot code. Use the
Utilities/Restart AN-X
command to
restart the AN-X in production mode.
Run Config Mode
The
Utilities/Run Config Mode
command is used to restart the currently
selected AN-X in configuration mode (normally used internally for
updating firmware).
This command is not used in normal operation but may be required for
technical support.
The AN-X is in configuration mode when the SYS LED flashes red
twice, followed by a pause.
To exit configuration mode, use the
Utilities/Restart AN-X
command to
restart AN-X in production mode.
