Pro'sKit SS-989, User Manual

Page: 6 / 19

5
●Turn on the power switch and the lamp will be lit
●Don‘t pull out the power plug instantly after turning off the power switch,
because the fan keeps operating to protect heat element. Until the fan
stops operation completely, the power plug should not be pulled out.
III. Calibrating the iron and hot air temperature
：
The soldering iron and hot air gun should be recalibrated after changing the iron/gun,
or replacing the heating element or tip/nozzle.
1. Connect the cord assembly plug to the receptacle on the station.
2. Set the temperature control the knob to 400°C (750°F).
3. Turn the power switch to 'ON' wait until the temperature stabilizes, Remove the
CAL pot plug.
When the temperature stabilizes, use a straight-edge(-) screwdriver or small plus(+)
screwdriver to adjust the screw (marked CAL at the station) until the tip thermometer
indicates a temperature of 400°C(750°F). Turn the screw clockwise to increase the
temperature and counterclockwise to reduce the temperature. Replace the CAL pot
plug.
IV. Operation instructions (SMD rework)
●
Remove SMD components (such as QFP, SOP, PLCC and so on)
1. Adjust air flow and heat gun temperature to desired level
2. Slip the pick-up puller (optional part)
under the component lead. (Fig. 4) If
the width of the component does not
match the size of the pick-up, adjust
the width of the pick-up by
squeezing the wire. In case of PLCC
or small components such as chip
resistors, desolder by using tweezers, etc.
3. Hold the heat gun up on the SMD components, but do not touch the
components, and allow the hot air to melt the solder. Be careful not to
touch the leads of the components with nozzle.
4. When the soldering tin is melted, remove the SMD components by
Fig. 4