Pro's Kit GE-537, Assembly & Instruction Manual

Page: 6 / 44

Trim off the burrs ONLY. Do not
trim off the protrusion belonged to
original plastic parts. All features of
parts should be kept completely.
請勿過度剪切非毛邊的塑膠零件，
以免組裝不確實，導致運作不良
3
It happens a lot some burrs are left at the edge of plastic parts after cutting them off.
Make sure the burrs are completely removed to avoid operation malfunction.
去除毛邊
Remove burrs
緊固螺絲
Fasten tapping screws
模型形狀、組裝方向與位置注意事項
Shape, assembly direction and position of parts
Use corresponding (size-compatible) screwdriver. By following steps
below, you can fasten the tapping screws perfectly.
Put the screwdriver
towards the top of
screws.
(1) Screw in
(2) Feel the tension getting higher
(3) Keep screwing
Please lock screws all the way
down to the bottom. If they are not
fastened tightly enough, parts may
come off. The product may
consequently not work.
Repeat until
screws are
tightly fastened.
Some parts may look quite similar.They should be assembled in the designated direction and position shown in manual.
務 必
注 意
Must-know
小技巧提醒
Read It Before Assembly
在開始組裝前，請仔細閱讀以下說明
Please read through and follow the tips below before assembly.
零件剪下時請將毛邊剪切乾淨，以免產生間隙導致運作不良
請使用正確的起子頭型(#1)，依照下面的步驟將螺絲鎖緊
將起子頭對準螺絲
(1) 開始擰轉
(2) 鎖固感越來越緊繃
(3) 繼續擰轉 重複動作直到無
法再擰動螺絲為
止
請務必將螺絲確實鎖緊至底
正確
Correct
錯誤
Incorrect
部份零件外觀相似，切勿混淆。請務必依照說明書指示的方向與位置進行組裝
正確
Correct
正確
Correct
錯誤
Incorrect
錯誤
Incorrect
錯誤
Incorrect
錯誤
Incorrect
正確
Correct
正確
Correct
正確
Correct
錯誤
Incorrect
Unnecessary
burrs
Unnecessary burrs
Unnecessary
burrs
毛邊
毛邊
毛邊