Page 5 of 6
1
Loosely fasten the Clamp Plates to Rod Holder Bodies via the two inward facing holes
(next to foam) using 2 x M6 Button Head Capscrews 40mm, 2 x M6 washers and 2 x
M6 Nyloc Nuts as shown.
2
Position the Rod Holder Bodies on each crossbar with the strap/foam ends pointing
towards each other. Slide the Clamp and Rod Holder assemblies onto crossbars at
an equal distance from the ends of the crossbars as pictured. Install the remaining
M6 Button Head Capscrews 40mm, M6 washers and M6 Nyloc Nuts into the
outward facing holes. Tighten all Nuts to 4Nm with a 10mm spanner or a suitable
Torque Wrench.
4
To secure rods, push the Zip Straps into the Buckles on either side of the Rod
Holders.
To release, push the top end of the Buckles inwards and lift Strap.
3
Your Fishing Rod Holder is now fitted and ready for use.
To use, place handle end of rod back into the main opening of the Rod Holder Body
and down into the foam. Place the rod tip into the foam on the opposite Rod Holder
Body as shown. Repeat for multiple rods, utilising the opposite end as required.
INSTALLATION ONTO PRORACK P-BAR AND OTHER SQUARE CROSSBARS
