Page 3 of 5
8
7
Slide 2x M8 nuts into the T-slot of the tray
Position holder centrally over a crossbar in the preferred position.
Secure the fuel container holder on to the M8 nuts in the T-slot using
2x M8 x 16mm set screws, 2x M8 spring washers and 2x M8 washers.
Use a 13mm spanner to tighten screws to 4-5Nm.
inSTallaTion FoR CaRGo TRayS WiTh T-SloT ChannelS
SeCuRinG The Fuel ConTaineR holdeR
9
Place the fuel container vertically into the holder ensuring the filler cap
is facing upwards as shown.
10
Loop the ratchet through the handle in the short strap around the
crossbar on one side of the holder and loop the long strap through its
handle around the crossbar on the other side of the holder.
Secure the holder with the straps and ratchet provided.
Ratchet is looped
around crossbar
and through itself
OPPOSITE SIDE
Strap is looped
around crossbar
and through itself
