Page 2 of 5
4
3
Position 2x M10 spring nuts into the crossbar channel either side of
tray slat where holder will be positioned. Push spring nuts down into
crossbar channel and twist to lock into place.
Use the assembled holder from step 1 to ensure spring nuts align with
holes in brackets.
Secure each mounting bracket on to the spring nuts in the crossbar
using 2x M10 x 25mm set screws, 2x M10 spring washers and 2x M10
washers. Use a 16mm spanner to tighten screws to 4-5Nm.
inSTallaTion FoR STandaRd CaRGo TRayS on PRoRaCK hd, TRadeSman and oTheR heavy duTy CRoSSbaRS
inSTallaTion FoR STandaRd CaRGo TRayS on PRoRaCK S-WinG and inTeRnaTional T-SloT CRoSSbaRS
Secure each mounting bracket on to the T-nuts in the crossbar using 2x
M10 x 20mm set screws, 2x M10 spring washers and 2x M10 washers.
Use a 16mm spanner to tighten screws to 4-5Nm.
6
5
Push rubber infill down and slide 2x M10 T-nuts into the crossbar
channel either side of tray slat where holder will be positioned.
Use the assembled holder from step 1 to ensure T-nuts align with holes
in brackets.
