ProRac Systems Inc.
Toll Free: 1-800-217-7133
7109 31
st
Avenue North
Phone: 763-546-5620
Minneapolis, MN 55427-2848
Fax: 763-546-0933
WWW.PRORAC.COM
5.
Adjust the rear crossbar so that the t-bolt lines up with the bracket.
Place the rear bracket over the t-bolt.
Tighten with knob
6.
Adjust the front crossbar so that the t-bolts line up with the front
holes on the bike support arm bracket.
Place the bike support arm bracket over the t-bolts.
Place the knobs onto the T-bolts and tighten.
4.
Assemble the wheel tray to the bracket using one nut, washer, and bolt provided.
Slip on plastic end protector.
3.
Assemble the bike support arm bracket to the wheel tray using the two nuts/ bolts/ washers provided.
It is important that the bike sits centered with the wheels roughly equal distance from the wheel tray ends with the bike support arm clamped into
position on your bike down tube.
If bike is not centered on the wheel tray, adjust by moving the bike support bracket along the wheel tray. Make sure the nuts are firmly tightened.
Slip on plastic end protector.
7.
Insert the rubber cushions into the bike clamp jaws.
8.
Place the bike into position and attach the clamp to the bike’s front down
tube.
The angle between the support arm and the bike should be approximately
90° (right angle)
The knob should be firmly tightened.
Remove the key and secure.
Black coated nut
