- 9 -
7.1 CONTROL PANEL
Figure 9 - Touch display
Nr. Symbol
Function
01 Setting the rotation speed of the Micromotor
Increase & decrease the speed of the micromotor by wiping
along the scale
02 Change rotation direction
Changing the direction of rotation (right/left)
03 Adjustment of the Suction power
Increase & decrease the suction power by wiping along the scale
04 Digital display of the suction power
Display of the suction power in percent
05 Suction
Switching the suction on and off
06 Warning dust bag
Lights up when the dust bag is full
07 Memory function
Selection of memory function M1, M2, M3
08 Warning notice Maintenance
Lights up as soon as the operating hours for regular maintenance
have been reached
09 Rotation
Switching the micromotor on and off
10 Digital display of the speed of the micromotor Display of the speed in steps of 1000 Rpm
• Do not use the handpiece if you want to change the direction of rotation. Wait until the direction of rotation has
changed before you continue working.
7.2 MEMORY FUNCTION
With the memory function, different speeds of the micromotor can be stored with the corresponding suction power. The
following settings are predefined at the factory. You can adjust these settings individually for yourself afterwards.
M1
M2
M3
Speed
6.000 RPM
15.000 RPM
10.000 RPM
Extraction capacity
99 %
99 %
99 %
Direction of rotation
right
right
right
Changing the memory function
To change the values in the memory function, proceed as follows:
(1) Switch on the device.
(2) Set the desired combination of rotation speed, rotation direction and suction power.
(3) Press the desired memory location M1, M2 or M3 for three seconds. Your set combination is now stored at the selected
memory location.
