PRO 5 PB/PBE/PBC
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
23
4.9. 140 mm spindle disk set
Allows
machining
pipes
from inside diameters of 105
mm (4.13’’) to outside diameters
of 140 mm (5.51
’’).
Included equipment consists of the following elements.
140 mm spindle disk
1 unit
Jaw blocks (number 7, 8, 9)
3 sets
Install the spindle disk after previously removing the existing spindle disk (Fig. 7, Fig. 8).
Then, use the following table to select jaw blocks of the set suitable to the inside
diameter of the pipe to be machined, and use the 3 mm hex wrench to tighten them
to the expanding mandrel (
1
, Fig. 2). Install the tool bits in the sockets and tighten the
screws (
3
, Fig. 2) with the 4 mm hex wrench.
Pipe inside diameter
with 140 mm spindle disk set
Jaw block
number
[mm]
[inch]
104.4
–116.6
4.11
–4.59
7
113.6
–125.8
4.47
–4.95
8
122.8
–133
4.83
–5.24
9
Part number:
ZST-0472-15-00-00-0
