PRO 5 PB/PBE/PBC
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
16
3.9. Replacing the spindle disk
Loosen the nut and use the 6 mm hex wrench to loosen the set screw (
1
, Fig. 7) by
at least one turn. Then,
rotate
the
spoke handles
to the left (
2
) to disengage the
mandrel from the machine (
3
).
Fig. 7.
Removing the mandrel from the machine
Use the 5 mm hex wrench (
1
, Fig. 8) and remove the spindle disk (
2
). Then, install
the new disk (
3
) onto the pin
4
and tighten with the same screws.
Fig. 8.
Replacing the spindle disk
1
2
3
1
2
3
4
