BM-21S
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
8
3. STARTUP AND OPERATION
3.1. Preparing
3.1.1. Adjusting the bevel angle and width
Unplug the power cord from the power outlet. Begin with setting the bevel width to
zero.
To do this, loosen the lock lever (Fig. 3) and rotate the knob to set the indication
‘0’ on the bevel width scale, and tighten the lever.
Fig. 3.
Initial setting the bevel width to zero
To set the required bevel angle (Fig. 4), use the 6 mm hex wrench to loosen two
side
screws,
rotate
the
guide
set
to
obtain
the
required angle on the scale, and tighten
the screws in this new position.
Fig. 4.
Setting the bevel angle (45° is set on the drawing)
Adhere to all safety precautions.
