Promix-SM213
7
See operating voltage range in 5.2. Avoid application of a higher voltage or
excessive pulse duration.
Provide a reliable electriccontact. To prevent short-circuit, insulate places of
connection.
6.2
CONNECTING PROCEDURE
The lock operation is controlled by means of energizing and de-energizing. For this purpose, a
controller (control board) or a switch (button) is generally used. The controller is mounted in
accordance with its certificate.
Connect the lock power wires adhering to the following polarity:
Red (black with a red stripe)
– positive pole of the power supply;
Black
– negative pole of the power supply;
Application of voltage of reverse polarity does not provide the lock operability but does cause
its failure.
Example of the lock connection to the remote control system Promix-RDS.
7.
SPECIAL ASPECTS OF INSTALLATION AND
OPERATION
1) The possibility of using of the locks for restriction of access to the premises and the place of
installation (outdoors or indoors) are determined by the
installation organization
on the
basis of the design features and the mounting method, room criticality level, the purpose of
the access restriction regime and other factors (the presence of security providers, video
surveillance, etc.).
2) During mounting the lock and the locking plate, it is necessary to ensure their coaxial
alignment within the catch free movement allowance.
3) NO lock may be mounted outdoors on condition that in winter it is closed (energized) for most
time. This prevents freezing of lubricant in the mechanism due to release heat.
NC locks are
not intended for outdoor installation.
4) The properly mounted lock provides the necessary free motion (play) of the door. If the free
play is absent, NC lock may
fail to open
when energized, and NO lock may
fail to close
when energized (see section 8).
5) Operation of an installed NC lock should be tested only if the supply voltage can be applied
thereto.
6) When using NC lock for restriction of access to rooms or in evacuation routes. Mounting of the
lock deblocking mechanism Promix-AD.KM.01 (delivered separately) is obligatory, since it is
necessary to provide exit for people in case of an emergency (e.g., fire).
Lock
Controller Promix-CR.RX
Remote control
Promix-CR.TX
~220 V
