1
Support flange on
the front end of
each rail
Front right label
Front left label
Guide pins on rails align with holes in the rack post
Installing the rails onto the rack
R
ail
K
it
S
pecificationS
Rack Type
Use with 19” equipment rack
adjustable length 600~900 mm (post to post)
Shipping Package Dimensions
370*380*740 mm
Shipping Weight
28 kg
Suitable Devises
3U and 4U enclosure hardware designed for 19” rack
Cautions
• Do not populate any unit with hard drives until it has been securely
installed in the rack.
• At least two persons are required to safely lift, place, and attach
the enclosure hardware unit into a rack system.
• Do not lift or move the enclosure hardware unit by the handles,
power supplies or the controller units. Hold the system itself.
• Do not install the enclosure hardware unit into a rack without rails
to support the system.
• Only a qualified technician who is familiar with the installation
procedure should mount and install the enclosure hardware unit.
• Mount the rails to the rack using the appropriate screws and flange
nuts, fully tightened, at each end of the rail.
• Do not load the rails unless they are installed with screws as
instructed.
• The rails available for the PROMISE enclosure hardware unit are
designed to safely support that PROMISE enclosure hardware unit
when properly installed. Additional loading on the rails is at the
customer’s risk.
• PROMISE Technology, Inc. cannot guarantee that the mounting rails
will support your PROMISE enclosure hardware unit unless you
install them as instructed.
p
acKage
l
iSt
•
Rail Kit Part Number: F29000020000101
•
Content of Rail Kit: 1 Pair of Supporting Rail Kit
R
ail
K
it
i
nstallation
of
Vt
RaK
/V
ess
/P
egasus
P
Ro
3u/4u e
nclosuRe
To install the enclosure hardware into a rack with the supplied mounting rails:
1.
Check the fit of the mounting rails in your rack system.
2. Adjust the length of the mounting rails as needed.
•
The rear rail slides inside the front rail. The rail halves are riveted together and use no
adjustment screws.
•
The front-left and front-right mounting rail ends are labeled.
•
Be sure the front rail support is on the bottom facing inward
•
All rail ends, front and rear, attach at the outside of the rack posts.
•
The guide pins at the rail ends align with the holes in the rack posts.
• Use the attaching screws and flange nuts from your rack system. Tighten the screws and
nuts according to instructions for your rack system.
M
ounting
the
e
nclosure
hardware
in
a
19”
rack
The instructions here apply to VTrak, Vess and PegasusPro 3U and 4U enclosure hardware. The
sliding rail rack mounting hardware is the same for both form factors.
