Electrical installation
1.
Turn the sensor adapter a quarter run in
an anticlockwise direction and remove
(bayonet fitting)
2.
Loosen the clamping screw on the con‐
nection and pass through the measuring
line from the control device
A0102
Fig. 3: 2-lead connection
3.
Strip the ends of the cables and connect
to the 2-lead connection: 1 = plus, 2 =
minus
4.
Bring approx. 5 cm of the measuring
wire into the sensor and tighten the
clamping screw on the connection
5.
Push the sensor adapter fully into the
housing and turn it carefully in a clock‐
wise direction until it can go no further,
ensuring that the nibs of the bayonet
fixing do not break off
Installation
41
