ProMinent Bello Zon CDKa 10000, Operating Instructions Manual

Page: 48 / 58

Pr o Minent ®
Page 48
Operating errors, help, troubleshooting
* • check if function plug is plugged in and if
cable is correctly connected
• mini-contact has been altered re-adjust
• check position of stop valves in bypass.
** • check solenoid valve “water feed”
• check level monitoring device float “EMPTY”
• check water feeding
• pc-board, check signal
1
when using turbine flow meter
Table 21: Error messages
malfunction message effekt delay red clear warn. Alarm corrective
LED relay relay action
flow monitor Acid pump metering stops after 8 flashes man. on on bleed or set
acid pump ERROR strokes monitoring element
flow monitor Chlorite pump metering stops after 8 flashes man. on on bleed or set
chlorite pump ERROR strokes monitoring element
flow monitor Water pump metering stops after 8 flashes man. on on bleed or set
water pump ERROR strokes monitoring element
acid level acid level metering on man. on change
initial warning low continues container
chlorite level chlorite level metering on man. on change
initial warning low continues container
acid level acid tank metering stops flashes man. on change
EMPTY container
chlorite level chlorite tank metering stops flashes man. on on change
EMPTY container
level monitoring Water tank! metering stops on man. on on ** find
device “EMPTY” cause
level monitoring Water tank! on water feeding
divice “FULL” too long
bypass flow bypass metering stops 0.7 sec. on auto. on * find
insufficient FAULT cause
bypass flow less bypass metering stops on auto. on * find
than main water flow
1
FAULT cause
pc-board fault flow input metering stops 5 sec. flashes man. on on check pc-board
or 3.7 mA > FAULT check signal
current signal > 23 mA
pc-board fault Rem.ctr.anlg. metering stops 5 sec. flashes man. on on check pc-board
or 3.7 mA > FLT check signal
current signal > 23 mA
pc-board fault Rem.ctr.anlg. metering stops 5 sec. flashes man. on on check pc-board
FLT
pc-board fault Dos.ctr.inp. metering stops 5 sec. flashes man. on on check pc-board
FLT
pc-board fault Byp.ctr.inp. metering stops 5 sec. flashes man. on on check pc-board
FLT
supply voltage - metering stops - off off an find
vailure cause