Promega QuantiFluor E6090, Technical Manual

Page: 9 / 28

Promega Corporation · 2800 Woods Hollow Road · Madison, WI 53711-5399 USA · Toll Free in USA 800-356-9526 · Phone 608-274-4330 · Fax 608-277-2516 · www.promega.com
Part# TM338 Printed in USA.
Page 8 Revised 1/11
QuantiFluor™-P Fluorometers
1. On the back of the instrument, loosen the screw and pull the screw up to remove the battery panel
(Figure 3).
2. Install the 4 AAA batteries into the appropriate spaces. Replace the battery panel and tighten the
screw. The panel has an o-ring, which creates a water-tight seal. The battery panel may be difficult to
install if there is no lubrication on the o-ring. Use a silicon-based grease to lightly lubricate the o-ring,
if necessary.
Figure 3. Back Panel of the QuantiFluor™-P Fluorometer showing the battery compartment.
Figure 4. Front Panel of the QuantiFluor™-ST Handheld Fluorometer. The control panel of the QuantiFluor™-P
instrument is identical.
8829T
A
UV
xx.x
Indicates active
channel.
Fluorescence reading.
A/B
button. Press
to select channel.
SET
button. Press to
select sample analysis
mode (Discrete or
Continuous).
READ
button. Press to
access READ screens.
DOWN ARROW
button.
ENTER
button.
CAL
button. Press to
access CALIBRATION
screens.
DIAG
button. Press to
access DIAGNOSTICS
screens.
ON/OFF
button. Turns the
instrument on and off.
STD VAL
button. Press to
set numeric value for the
standard solution.
DATA
button. Press to
access IDL screens
(Internal Data Logging).
ESC
button.
HOME
screen.
UP ARROW
button.
8827T
A