Promeba PB-410 Series, User Manual

Page: 16 / 28

16
USER GUIDE // STRETCHER SUPPORT SERIES PB-410
Review 2022/01
03
OPERATION
FIGURE 1
FIGURE 2
03.1 Transport and storage
Before transporting the product, make sure that it is properly packed.
During transportation, always secure the load. Transport the load le-
veled and following all the precepts and rules for the transport of
loads, also making sure that there are no risks of bumps or falls du-
ring the transport itself.
Before moving the product, remove the packaging carefully to not
damage the exterior of the stretcher support . Keep the original pac-
kaging for use in any other transportation and for storage.
To move the product, a crane (for elevated load) or a forklift can be
used. Follow the instructions below in each case:
Transport with crane (Fig. 1)
- Pass some straps through the upper platform for transport. (As indi-
cated in the graphics)
- Transport the load leveled and following all precepts and regula-
tions regarding the transport of suspended loads.
Transport with forklift (Fig. 2)
- Put a pallet or flat surface under the bench and transport crosswise.
- Do not load the stretcher support directly on the forklift without a
pallet or flat support surface.
- Do not load the stretcher support longitudinally on the truck if you
do not have a sufficiently long base.
Product damage caused during shipping and handling is not cove-
red by warranty. Repair or replacement of damaged parts is custo-
mer’s responsibility.
The device should be stored in a cool, dry place, away from direct
sunlight. It must not be in contact with chemical substances or
agents that can cause damage and reduce its safety performance.
TRANSPORT WITH CRANE
TRANSPORT WITH FORKLIFT TRUCK
03.2 Preparation
Upon receipt of the product:
- Remove the packaging and expose the material so that all components are visible.
- Check that all components/parts on the attached list are present.
The device must be checked before each use to reveal any malfunction and/or damage caused by transport
and/or storage. In particular, check:
- General functionality of the device
- Cleaning of the device (remember that the lack of cleaning can cause the spread of infections)
- Absence of cuts, holes, breaks in the structure
- Correct fixing of all nuts, bolts and screws
- State of moving parts
- Component integrity
- Lubrication of moving parts
- The movements of extraction and inclination and the locking in the different positions.
- The operation of the Trendelenburg movement
- The operation of the extra longitudinal displacement, if it has it.