Promeba PB-410 Series, User Manual

Page: 19 / 28

USER GUIDE // STRETCHER SUPPORT SERIES PB-410
Review 2022/01
19
03
OPERATION
03.2.2 ADJUSTMENT OF THE LOAD ANGLE
Follow the steps below to adjust the stretcher support in the optimal loading position according to the
available stretcher:
- Once the stretcher support is installed inside the ambulance, remove the platform as indicated in point
03.3.1 and unfold the ramp.
- Place the stretcher with the attack wheels on the ramp and slide it forward until the front legs touch the
ramp roller.
- Tilt the platform (as indicated in point 03.3.1) so that, when the stretcher is in this position, the front wheels
are at least 5cm from the ground (see figure 3).
- Remove the stretcher but do not modify the inclination of
the platform.
- Locate the adjustment supports that are placed in the cen-
tral inner part of the platform, on both sides, and that have
the roller that acts as a stop when tilting the platform com-
pletely (see figure 4).
- Loosen the two screws of both supports and place the rollers
in contact with the base of the stretcher support, as shown in
the illustration.
- Retighten the screws.
This operation must be carried out with the ambulance pla-
ced on a uniform and perfectly horizontal surface and with
two operators seated in the patient compartment (simulating
a load of approximately 250 kg).
If the vehicle is equipped with pneumatic or hydraulic suspensions, the loading height adjustment must
be made taking into account the worst conditions of use and/or the operating conditions provided by the
vehicle manufacturer. Problems during use and/or safety risks associated with such a system cannot be
attributed to the manufacturer.
Test the loading and unloading procedures with an empty stretcher before putting the stretcher support
into service.
ATTENTION: Do not use the bench until it is correctly adjusted
5 c
m
FIGURE 3
FIGURE 4