ProMariner ProNautic 1210P, Instruction Manual

Page: 2 / 16

Unpacking And Inspection:
Thoroughly inspect your ProNauticP unit. The package should contain the following:
1) ProNauticP Charger
2) Parts package including:
a. Owners/Installation manual
b. Warranty Card
c. Temperature Probe
DAMAGE – If any parts are missing or damaged, or the unit has been damaged in
shipping contact ProMariner Customer Service at 1-800-824-0524, please do not
take it back to place of purchase.
DO NOT attempt to install or operate the unit if it has been damaged in any way.
1
Table of Contents
Introduction... 1-3
CAUTIONS, WARNINGS AND SAFETY INSTRUCTIONS… 4-8
Installation... 9-14
Setup and Operation… 14-17
Programming... 18-20
Troubleshooting... 20
Maintenance... 21
Dimensions... 22-24
Typical Wiring Configuration... 25-27
Warranty Information... 28
12 Volt Models 24 Volt Models
10 Amps PP1210 – 2 Output 20 Amps PP2420 – 3 Outputs
15 Amps PP1215 – 3 Outputs 30 Amps PP2430 – 3 Outputs
20 Amps PP1220 – 3 Outputs
30 Amps PP1230 – 3 Outputs
40 Amps PP1240 – 3 Outputs
50 Amps PP1250 – 3 Outputs
60 Amps PP1260 – 3 Outputs
1 . Cooling Vent 6 . AC and DC Connection Cover
2 . Amperage Out Display 7 . DC Side Terminations
3 . Percentage of Outputs Used 8 . AC Side Terminations
4 . Faults 9 . Voltage Out Display
5 . Charging Profile Selected 10 . ABYC Recommended Bonding Stud
2
Introduction
20
8 7
6
4
3
2
1
5
9
10
1 2 3 3
Battery Profiles Charger Conditions
Charger Mode Ready Conditioning Charging
AC Power
Auto Temp Control
Active PFC
Amps Volts
SYSTEM DC OUTPUT LEVELS
Variable Speed Cooling
Self Test
Fault
OK
Standby AUTO CONSERVATION MODES
100% 0%
Battery Health Program
Equalization
Charger Output
SETUP
ENTER
SELF TEST: Hold all keys 5 seconds
WARNING: HIGH VOLTAGE
ATTENTION : HAUTE TENSION WARNING: LOW VOLTAGE
ATTENTION : BASSE TENSION
AVOID SERIOUS INJURY OR DEATH FROM ELECTRICAL SHOCK. BEFORE OPENING
TURN OFF AC SUPPLY POWER. DO NOT EXPOSE TO RAIN OR SPRAY.
CHOC ELECTRIQUES PEUVENT PROVOQUER LA MORT OU DE SERIEUSE BLESSURES.
AVANT D'OUVRIR LA BOITE, COUPER LE COURANT. NE PAS EXPOSER AUX INTEMPÉRIES. ELECTRICAL BURN AND SPARK HAZARD. BEFORE OPENING
DISCONNECT CHARGER CONNECTIONS AT BATTERIES.
(DANGER DE BRULURES ELECTRIQUE ET ETINCELLES). AVANT D'OUVRIR LA
BOITE DECONNECTER LES CONNECTIONS ENTRE CHARGEUR ET BATTERIE.
P
reset-1
P
reset-2
Flooded
Sealed
AGM
GEL
LiFePO4-Lithium
Calcium/Custom
Reverse Polarity
DC Volts Low
DC Volts High
Charger High Temp
Check Fan
Digital Pro Mar
Performance Charging
ProNautic 12
•
60 P
Power Factor Corrected & Global AC Input