Promaker PRO-SD360, User Manual

Page: 7 / 24

7
tighten screws.
• When screwing in wood, it is
recommended to drill a hole with a
depth equal to almost the length of
the screw. A pilot hole guides the
screw and prevents splintering or
distortion of the work piece.
5. CHARGING THE BATTERY
Charging Li-Ion battery
Fig.10
The battery charger supplied is
matched to the Li-Ion battery
installed in the machine. Do not use
another battery charger.
The Li-Ion battery is protected
against deep discharging. When
the battery is empty, the machine
is switched off by means of a
protective circuit: the tool holder no
longer rotates. Caution: if the On/Off
switch is subject to continued use,
the Li-Ion battery can be damaged.
The charging procedure starts as
soon as the mains plug of the battery
charger is inserted into the socket
and the adapter plug is connected
to the appliance (the underside of
the handgrip).
• Put the adapter plug of the charger
into the handle (underside).
• Plug the mains adapter into the
(wall) socket.
• The charging process starts; the
red LED is now on.
• The battery is fully charged when
the red LED goes out.
• Charging the battery takes
maximum 5 hours.
• During the charging procedure, the
handgrip of the machine warms up.
This is normal.
6. SERVICE & MAINTENANCE
Make sure that the machine is
not live when carrying out
maintenance work on the motor.
These machines have been designed
to operate over a long period of time
with a minimum of maintenance.
Continuous satisfactory operation
depends upon proper machine care
and regular cleaning.
Cleaning.
Keep the ventilation slots of
the machine clean to prevent
overheating of the engine.
Regularly clean the machine
housing with a soft cloth, preferably
after each use. Keep the ventilation
slots free from dust and dirt. If the
dirt does not come off use a soft
cloth moistened with soapy water.
Never use solvents such as petrol,
alcohol, ammonia water, etc. These
solvents may damage the plastic
parts.
Lubrication.
The machine requires no additional
lubrication.
Faults.
Should a fault occur, e.g. after
wear of a part, please contact the
service address on the warranty