Promac PBM-1839BDV, Operating Instructions Manual

Page: 11 / 28

11
An undersized cord will cause a drop in line voltage resulting in
loss of power and overheating.
Only use extension cords marked H07RN‐F, with wires 1,5mm2
or more.
The total length of cord may not exceed 18 Meter
Extension cords and plugs must be free from defects.
8.0 Setup and Adjustments
8.1 MT3 Arbor replacement
Remove the draw bar cover (X, Figure 8‐1).
Figure 8‐1: MT3 Arbor replacement
Stop spindle rotation with the supplied spanner.
Loosen the draw bar with a hex socket wrench (Y).
Loosen the drawbar by 2 to max 3 full turns.
Tap the drawbar head with a rubber mallet to dislodge the
MT3 tool taper.
8.2 Engaging the fine feed hand wheel
To activate the fine feed hand wheel (C, Figure 8‐2) tighten the
engagement knob (F).
Figure 8‐2: Engage fine feed hand wheel
9.0 Operating Controls
Refer to Figure 9‐1:
N ............................................... Spindle speed display
O ............................................ Emergency stop switch
P ............................................................. Start button
Q ..............................................................Stop button
R .......................................... Forward‐rotating button
S ........................................... Reverse‐rotating button
T ....................................................... Speed‐up button
U ........................................... Speed reduction button
V ........................................... Tapping function button
Figure 9‐1: Operating Controls
Refer to Figure 9‐2:
AA ................................................ Change mm to Inch
BB ................................................................... ON/OFF
CC .................................................... set display to “0”
DD ............................................ battery compartment
(slide to right to open….battery type SR 44 or LR 44
).
Figure 9‐2: Drill Depth Display