Operation Manual
Total 26
page 20
When the foundation is completely dry, the machine could be laid down on the adjustable
pad. Concrete could be filled when screw bolts are placed. Fastening screw bolts after
concrete is completely dry. Leveling the machine first, required tolerance should not be
over 0.04/1000mm both in horizontal and cross plane. Checking all items of the accuracy as
per the table sheet of the certificate. Accuracy value for each checked item must not be over
the required value.
6.3
Preparation before machine running:
A strict checking, testing and try cutting of the machine have been made before machine
delivery. No adjustment of the machine itself is necessary. Before machine running, clean all
surfaces of the machine first by using cloth with kerosene or gasoline, checking all
lubrication points then turn the main switch of the machine to the “on” position, running the
machine with middle or slow speed and checking all revolution direction is correct, operating
levers are in a correct position, checking machine noise and working temperature are all ok.
The machine should be running for a certain period of time, then it could be used if no any
un-normal condition happened.
7.
Use and operation of the machine
:
7.1
For the operating levers, handles and buttons, please refer to the diagram 1 and diagram 4.
Handle
、
Button
、
Switch table
No
Description
No
Description
1
Table Lifting Handle
12
Spindle inching Button
2
Scale Adjusting Handle
13
Handel for Speed Adjust of Spindle
3
Micro Hand wheel
14
Clamping & Releasing Tool Handle
4
Feed Lever
15
Emergency Stop
5
Feed Variation Lever
16
Drilling/Tapping Switch
6
Table Lifting Button
17
Cooling Pump Switch
7
Spindle clamp grip
18
Main AC switch
8
Working light switch
19
Coolant flow control switch
9
Main shaft covers handle
20
Lever lock handle
10
Spindle reversal button
21
Working Table Clamping Handle
11
Spindle stop button
22
Bracket Clamping Handle
7.2
Mounting and dismounting of tool cutters:
The machine equipped with a tool dismounting device to be controlled by a nob ( 15 ). Push
forward the nob ( 15) to the spindle box direction when tool mounting is required. As for
dismounting tool cutters, pull out the nob ( 15 ), hold the tool cutter by left hand,
meanwhile, turn the feed lever ( 4 ) by right hand, then the spindle quill goes up rapidly,
the tool cutter will fall down until tool taper shank strokes the shaft of spindle.
