Proluxe TORTILLAPRO DP2000PAUB, Operation Manual

Page: 6 / 18

-5- DP2000-1725-7/04
No. DPPC1. (See our catalog
and price list for information.)
Note: This spray will not affect
the taste of your crust in any
way.
6.
Place your pre-portioned ball of
dough in the approximate center
of the lower platen. Add another
dash of spray to the top of the
dough ball.
7. Close the platen and pull the “U”
shaped handle down to
commence the pressing
operation.
8. Hold the handle down for as long
as you have determined to be the
appropriate amount of time for
your particular product and then
simply pull the handle back up
when you have completed.
9. Inspect your dough. If it is too
thick, rotate the thickness control
dial, located on the top of the
machine, to the line marked
“THIN”. Reverse this procedure
if your product presses too thin.
Experiment with temperature,
dough weight, time, and pressure
until you arrive at the desired
result.
10. Remove the finished product by
rotating the upper platen out of
the way until you have sufficient
space to do so. Place the dough
on a screen or in a pan. Since the
shape of the dough may be
altered slightly in the transfer
process, some hand fitting may
be required. Add toppings, if
desired, and now you are ready
to bake.
ADDITIONAL NOTES:
Temperature
Note
Fahrenheit/Centigrade (Celsius)
Conversion
The temperature controller can
be programmed to display either
°F or °C. To change: Press the
MODE button until the
temperature is displayed, then
push and hold the
SET button for
10 seconds.
Counter
The controller has a built in cycle
counter.
•
Press MODE button until the
counter is displayed.
•
Counter display range is 0000 to
9999 .
•
To reset the cycle counter,
display the counter reading, then
push and hold both UP (
V
) and
DOWN (
W
) arrow buttons for 3
seconds until the counter resets
to zero (
0000 ) on the display.
Tightening the Pull-Down Handle
The pull-down pressing handle requires
adjustment periodically to prevent it
from free falling. Whenever the handle
seems too loose or is falling by itself, the
problem can be corrected easily and
quickly as follows:
1. Using a 3/16” hex shaped Allen
wrench, insert in key slot located
on the right
beneath the upper
shroud.
2. Tighten until the press action of
the handle becomes firm but not
too tight.