depressing button.
controller until button activate.
Same goes in reverse if buttons
are held down by the overlay.
Digital display shows
relay and particular
zone is overheating.
1. The relay on the switched side is
not opening to regulate temperature.
1. Replace the relay.
92
Beeper not
functioning or
intermittent beeper
sound.
1. Beeper on digital control board
failed.
1. Replace digital controller
board
85
Power is on but hear
a leaking of air under
the lower platen /
swing arm while
press is idle.
The O'rings are worn allowing the air
to pass through the cylinder
The cylinder needs o-rings,
gasket
and new cylinder grease. Request
instruction sheet and need to
order P/N 110033 for the kit.
----
Press does not close
when pressing the
two, green, start
buttons
Did not simultaneously press the
start buttons exactly at the same
time.
Try pressing both buttons exactly
at the same time. This is a
anti-tiedown safety feature.
2
If setpoint is reached
but slightly off in
temperature.
Offset may need to be calibrated and
adjusted.
Call (800) 624-6717 ext. 129 for
instructions.
----
After activation
lower platen and
when the cycle is
complete, the lower
platen either is very
slow coming down or
doesn’t come down
at all.
The Mufflers on the Solenoid Valve
are dirty and now allowing air from
passing though.
Replace both Solenoid Valve
mufflers.
----
Thickness crank on
top of press turns
endless.
Set screws on crank maybe loose
Make sure shaft is all the way on
thin setting by turning counter
clockwise then tighten the
stacked allen screws (2 set
screws on top of each other) with
allen wrench.
A5
Dough not having
same thickness
across the press
dough.
To adjust upper platen for level press
Underneath the housing you will
find 4, stacked hex bolts sitting
over the upper platen attached to
the arm. The top bolts are called
locking bolts. The 4 larger hex
bolts below are adjustment bolts.
break free the 4 Locking bolts.
11
&
12
7
