9
To prevent corrosion, the Alu Racing jack should be cleaned and dried after use in a damp environment.
All moving parts must be greased regularly with bearing grease.
Repairs
Repairs of an Alu Racing jack may only be carried out by qualified persons and are subject to the decision of the
manufacturer.
Never try to repair the product yourself.
In the event of doubt about its proper functioning, the Alu Racing jack must be removed from service for inspection by an
expert.
Also, do not use the product in the event of:
- fracture, deformation, sharp notches or cracks of any kind
- wear and excessive corrosion
Regular inspections
Perform a visual inspection before each use to detect any damage.
Damaged jacks must not be used.
Troubleshooting
Disposal
Collect used oil or leaking oil in a special container and take it to a waste oil disposal point. Dispose of the jack properly.
Warranty
The warranty expires if the product is used improperly and if the information in these operating instructions is not
observed.
Further warranty provisions can be found in the General Terms and Conditions of ProLux Systemtechnik GmbH & Co KG.
Interval
Description
Regularly as required
Top up oil
After each oil top up
Venting the hydraulics
After prolonged non-use
Venting the hydraulics
After 3 to 6 months
Grease all moving parts
Problem
Reason
Solution
The load cannot be lifted.
1. Drain screw not tight enough.
2. Oil quantity too low.
1. Tighten the drain screw clockwise.
2. Top up with oil.
The load is not held in the
raised position.
The oil level is too low or there is air in the
system.
Top up oil and/or vent the system (see
section Initial operation).
The lift arm does not
reach the maximum
height.
The oil level is too low or there is air in the
system.
Top up oil and/or vent the system (see
section Initial operation).
The lift arm does not
lower completely.
The return spring is worn out or unhooked.
Have the return spring replaced by a
specialist. (Clean and lubricate moving
parts regularly.)
English
Originalbetriebsanleitung – Rangierwagenheber Alu Racing Jack 3000 kg / 2000 kg
