11
STUdiocoBfc
Number of
DMX channels
Start address
(example)
DMX Address
occupied
Next possible start
address for unit No. 1
Next possible start
address for unit No. 2
Next possible start
address for unit No. 3
3
33
33-35
36
39
42
5
33
33-37
38
43
48
8
33
33-40
41
49
57
3.7 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press the button MENU so many times until the display shows
Master/Slave
and press the button ENTER.
• Press UP/DOWN to set the unit as master or slave
(Master/Slave)
.
• Select the desired program (see section 3.4).
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 13).
3.8 LINKING
1. Connect the DMX OUT of the master unit via 3/5-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
3.9 DMX CONFIGURATION
STUDIOCOBFC is equipped with different DMX configuration.
• Press the button MENU so many times until shows
DMX Channel
, and press the button ENTER to confirm.
• Select the desired DMX configuration (
3CH - 5CH - 8CH
) through the buttons UP/DOWN.
The tables on page 14 indicate the operating mode and DMX value. The STUDIOCOBFC is equipped with
3/5-pole XLR connections.
3.10 DMX ADDRESSING
• Press the button MENU so many times until the display shows
DMX Address
, and press the button ENTER
to confirm.
• Press UP/DOWN button to select the desired value (
001-512
). Press and hold to scroll quickly.
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
To able to operate the STUDIOCOBFC with a light controller, adjust the DMX start address for the first a
DMX channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX
channel, adjust the start address 33 on the STUDIOCOBFC.
The other functions of the light effect panel are then automatically assigned to the following addresses.
An example with the start address 33 is shown below:
Summary of Contents for STUDIOCOBFC
