ProLights STUDIOCOBFC, User Manual

Page: 30 / 44

STUdiocoBfc
10
3.4 AUTO SHOW
If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
• Press the button MENU so many times until the display shows Auto Show , then press the button ENTER.
• Press the button UP/DOWN to switch between the show Auto 1 - Auto 4 . The unit will operate in show
mode.
• Using the button UP/DOWN to select the desired run speed slow-fast
0-100
.
• Press the button ENTER to save the setting.
IMPORTANT: Programs Auto 1 - Auto 4 are fully pre-programmed and will not be altered by changes. Instead,
3.5 STATIC MODE
This fixture has the ability to accept custom static color settings. Access these chases via the control panel
on the back of the fixture.
• Press the button MENU so many times until the display shows Static , then press the button ENTER.
• Select Fixed Color through the buttons UP/DOWN, then press the button ENTER.
• Set the colors
R , G , B, GB, RB, RG, RGB
, through the buttons UP/DOWN, then press the button ENTER.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.6 MANUAL MODE
This mode allows to combine the colors red, green and blue
(R, G, B)
.
• Press the button MENU so many times until the display shows Static , then press the button ENTER.
• Select Manual Color through the buttons UP/DOWN, then press the button ENTER.
• Select the color R, G, B through the buttons UP/DOWN, then press the button ENTER.
• Using UP/DOWN button, select the desired color value 000 - 255 .
• Press ENTER button to continue to the next color
R, G, B
.
• Continue until the desired mix is obtained.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
10 White Balance
ð
R = 255
ð
R = 255
ð
G = 255
ð
G = 255
ð
B = 255
ð
B = 255
11 LED Frequency
ð
600 Hz
1200 Hz
2000 Hz
4000 Hz
25 KHz
12 Temperature
ð
40°C