SPIRIT
10
- 3 - MAINTENANCE
3.1 CLEANING AND STORAGE
•
A water collection tray is equipped at the rear of SPIRIT, when the compressor is running for condensed
fog, some water drops will flow into the tray. Please check if the water in the tray is full and drain it
routinely.
NOTE - If the machine is to be used for long time or the water drops can not be checked momentarily,
the water collection tray can be removed and a 6 mm PU hose can be connected to the water draining
hole located at the upper of the water collection tank to directly drain out the water drops. After finish-
ing draining, push up the upper red button to remove the hose.
•
The SPIRIT machine is equipped with a pump temperature sensor, when the fog fluid is used up in the
tank, pump will stop running due to the rising of the temperature. When the machine temperature
drops down, the pump will resume to run. Please check to see if the fog fluid is sufficient in the fluid
tank.
•
A black square metal mesh is located at the back of the machine. It is the air inlet of the fan, please do
not block it and clean it routinely to keep the cleanness.
•
If the fog volume is too low, the machine generates noise during operation or the fog cannot be
smoothly sprayed, please turn off the power immediately and check if the fog fluid is sufficient, wheth-
er the external fuse, controller connection or power supply has any problem. If none of the above
shows any problem, insert the power plug again, if the machine still cannot normally operate, please
check whether the hose connecting to the fog tank is blocked, an fluid is flowing. If the cause cannot
be identified, please do not allow the machine to operate to avoid the damage of it. The machine shall
be turn off immediately to cooling down, please return the machine to your dealer.
•
The feature of SPIRIT is to allow the fog flowing along the surface of the floor after outputting, after
using it for a long time, the floor will become slippery due to the moisture. Please note the material of
the floor and pay special attention to the safety of the performers or walking on it.
•
Cleaning your fog machine regularly can help you to reduce the frequency of parts replacement and
the cost of maintenance.
•
Please do not contaminate fog fluid, put the cap on the tank at all time and the cap of the fog liquid
tank equipped on the machine.
•
If the fog machine is not in use, please clean it before storage. Store the fog machine in a dry and cool
place.
