NANOLASER series
10
- 3 - FUNCTIONS AND SETTINGS
3.1 BASIC
This product includes an external power supply which is auto-ranging and runs on 100~240 VAC, 50/60
Hz power. Only use the included power supply! Before powering on the unit, make sure the power supply
voltage to which you are connecting it is correct. Connect the connection cable of the power unit with the
DC in socket. Plug the power unit into your outlet. Switch on the unit with the MODE button, pressing for
2.5 second. After operation, switch off the unit with the same button.
ATTENTION - To determine the power requirements for a particular unit, see the label affixed to the back
plate of the unit or refer to the unit’s specifications sheet.
•
All devices must be powered directly off a switched circuit and cannot be run off a rheostat (variable re-
sistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100% switch.
•
Before applying power to a fixture, check that the source voltage matches the fixture’s requirement.
This information is located on the power adaptor that is included with your unit.
3.2 OPERATION
Access the four different operating modes available in this product by using the MODE button on the front
panel. Press MODE to cycle through the modes. Please see a description of each mode below.
MODE
DESCRIPTION
LED INDIC ATOR
1
AUTO Emotion
LED is red
2
AUTO Smooth
3
SOUND Activated
LED is blue
4
SOUND Strobing
3.3 REMOTE CONTROLLER
The controller allows remote control of auto-shows, sound-active, effect library with speed adjustment.
1. TURN THE LASER ON/OFF
2. MUSIC SHOW
3. AUTO SHOW
4. CYCLES THROUGH COLORS
5. CYCLES THROUGH COLORS
6. PAUSE THE EFFECT
7. MANUAL MODE
8. ROTATE EFFECT DIRECTION (In
Manual Mode)
2
3
4
1
5
8
6
7
Fig.4
