ProLights ARCPOD27Q, User Manual

Page: 13 / 40

11 ARCPOD27Q
3.13 FACTORY DEFAULT
To reset the device of the factory default proceed as follows:
• In the main menu of the DATAMASTER select
RDM .
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll through the menu, select the Factory Default , then press the ENTER
button to access the next menù to choice the Yes or No.
• Press the MENU button repeatedly to exit the menu and to save the changes made.
3.14 MANUAL COLOR
To enter this mode proceed as follows:
• In the main menu of the DATAMASTER select
Stand Alone.
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll through the menu, select the
Manual Color
then press the ENTER but-
ton to access.
• Use the arrow buttons to set the desired mixing color ( Red, Green, Blue, White ) with the relative value ( 000-
255 ). Press the ENTER button to confirm.
• Press the MENU button repeatedly to exit the menu and to save the changes made.
• NOTE: once you have set up the mixing of desired colors with the mode described, to change this at a
later time it is necessary to start again with the Factory Reload mode.
3.15 EFFECTS
To enter this mode proceed as follows:
• In the main menu of the DATAMASTER select
Effects.
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll through the menu, select the Effects then press the ENTER button
to access.
• Use the arrow buttons to set the desired effect ( Effect1, Effect2, Effect3, Effect4, Effect5 ) with the relative value
(
000-125
). Press the ENTER button to confirm.
• Press the MENU button repeatedly to exit the menu and to save the changes made.
• NOTE: once the desired effect has been set with the described mode, to change it at a later time it is
necessary to start again with the Factory Reload mode.
NOTE: If the projector is in Blackout mode before to receive DMX signal, and if the DMX signal is lost, the
projector will remain on according to the last received DMX value. If the projector was in STATIC or AUTO
mode before to receive DMX signal, if the DMX signal is lost, the projector will return to the previously set
STATIC or AUTO.