ProLights ARCLED7507QZOOM, User Manual

Page: 34 / 52

ARCLED7507QZOOM
10
3.4 AUTOMATIC MODE
If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
• Press the button MENU so many times until the display shows AUTO , then press the button ENTER.
• Press the button UP/DOWN to switch between the programs ( AT. 01 - AT.10 or PR.01 - PR.10 ).
• Press ENTER button to confirm your choice and then select the speed of the program (
P.000-255
) using
the UP/DOWN buttons. Press the ENTER button again to confirm your choice. The unit will operate in
automatic mode.
NOTE - Programs AT.01 - AT.10 are fully pre-programmed and will not be altered by changes in EDIT mode.
Programs PR.01 - PR.10 are fully pre-programmed and can be edited in EDIT mode.
In automatic mode the unit will be set as Master.
3.5 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press the button MENU so many times until the display shows RUN , and press the button ENTER to
confirm.
• Press UP/DOWN to set the unit as SLAV .
• Select the desired program (see section 3.4).
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 11).
3.6 LINKING
Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3/5-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
3.7 DMX CONFIGURATION
ARCLED7507QZOOM is equipped with 10 DMX configuration.
• Press the button MENU so many times until shows PERS, and press the button ENTER to confirm.
• Select the desired DMX configuration
TOUR - TR16 - ARC.1 - AR1.D - ARC.2 - ARC2.D - ARC2.S - HSV - AR2.Z - FULL
through the buttons UP/DOWN.
The tables on page 14 indicate the operating mode and DMX value. The ARCLED7507QZOOM is equipped
with 3 - 5 pole XLR connections.
3.8 DMX MODE
• Press the button MENU so many times until the display shows RUN , and press the button ENTER to
confirm.
• Press the buttons UP/DOWN to select DMX mode.
• Then enter the
DMX
mode to set the ID address.
• Press the buttons UP/DOWN to select the desired value 001-512 .
• After the setting value is automatically saved.
NOTE - When fixtures are under Auto program operation, the RUN mode does no works.