Project Food AKD200F, Installation, Operating And Service Instructions, Page: 29 / 72

29
- 29 -
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
7. Troubleshooting
PROBLEM CAUSES SOLUTION
Insufficient cooling
power

Direct sunlight or near heat sources.

Control unit is performing a defrost
cycle.

The door is not completely closed or
has been opened too long.

The door seal is damaged or
deformed.

The evaporator is covered in ice.

Dirty condenser coil.

Move the appliance away from the heat
sources.

Wait for the control unit to complete
the defrost cycle (max. 20 minutes).

Close the door completely, keep the
door open for shorter periods of time.

Contact the dealer.

Check that the door and the gasket seal
well and that no hot food has been put
inside the appliance. Contact the dealer.

Clean the condenser coil (see section 6
"Cleaning and servicing").
Not cooling

The electric plug is not inserted in the
socket.

The compressor does not turn on.

Power failure

Insert the electric plug in the socket.

Contact the dealer.

Check the power supply.
The appliance leaks
water (only versions
R, R SS and RG)

The water elimination device is
damaged, the discharge has not been
well channeled or is blocked.

The appliance is not positioned on a
flat surface or the legs are not
properly adjusted.

Make sure that the water elimination
device is well channeled and the
discharge is not blocked.

Place the appliance on a flat surface and
adjust the legs so that the appliance
rests solidly on the ground.
Very noisy

The appliance is not positioned on a
flat surface or the legs are not
properly adjusted.

There is a vibration caused by loose
screws or bolts.

Place the appliance on a flat surface and
adjust the legs so that the appliance
rests solidly on the ground.

Check that the screws and bolts have
not become loose during operation or
transport.
The compressor does
not shut off
automatically

Too many products inside the
appliance.

The door is not closed or has been
opened too long.

Remove excess products.

Only open the door as long as necessary
and check that it is properly closed.
The above cases are presented merely as examples of possible problems. In the event of any
problem, immediately switch the appliance OFF and contact the dealer.
The following characteristics are normal and do not represent malfunctions:

At regular intervals the temperature indicated on the digital control unit display increases by
4-5 degrees with respect to the set-point and then decreases: this is part of the normal
cooling cycle of any refrigerating appliance. See the detailed explanation in sect. 5.4.

The sound of flowing water. This sound occurs during normal use. It is the sound of the
coolant expanding inside the cooling circuit.

When there is high humidity, condensate on the internal part of the door is normal. Remove
the condensate by wiping it off with a soft cloth.
Requesting spare parts:
To request spare parts, contact the dealer and refer to the part number indicated in
the spare parts drawings at the end of this handbook (Section 11), also indicating the
appliance’s model and serial number.