Rev: 05.21.18
Page 7
EuroLoft™ Bed Lift (Overhead) OEM
NOTE: A prefabricated jig may be used for a faster installation of the belt brackets.
NOTE: If installing on a unit with aluminum backing in the wall, use a minimum size of #10 x 1" self-drilling
screws. If installing on a unit with wood backing in the wall, use a minimum size of #10 x 1" wood
screws.
2. Starting on the passengers side at the desired height, install a belt mounting bracket (Fig. 13A). The left
edge of the belt mounting bracket should be approximately 10 1/4" away from the top roll bar of the
unit.
3. Install seven #10 x 1" screws at the top and seven #10 x 1" screws at the bottom of the belt mounting
bracket into wall of the unit.
4. On the passenger's side, place the second belt mounting bracket's left edge approximately 47 1/2"
away from the top roll bar of the unit.
5. Install seven #10 x 1" screws at the top and seven #10 x 1" screws at the bottom of the belt mounting
bracket into wall of the unit.
6. On the driver's side at the desired height, install the third belt mounting bracket's right edge of the
bracket, approximately 12 3/4" away from the top roll bar of the unit.
7. Install seven #10 x 1" screws at the top and seven #10 x 1" screws at the bottom of the belt mounting
bracket into wall of the unit.
8. Place the fourth belt bracket's right edge approximately 46 1/2" away from the top roll bar of the unit.
9. Install seven #10 x 1" screws at the top and seven #10 x 1" screws at the bottom of the belt mounting
bracket into wall of the unit.
10. Place the bottom side of the bed frame down on level supporting saw horses at the approximate fully
extended position. Make sure the bed frame is level.
11. Extend one belt up from the bed frame, making sure the belt is not twisted and there is no slack in the
belt.
12. Wrap the belt (Fig. 14C) over the top of the first belt plate (Fig. 14B). The belt extending up from the
bed frame should be in between the belt mounting bracket and the belt plate.
13. Place the belt plate and the belt onto the posts (Fig. 14A) of the belt mounting bracket.
14. Slide the second belt plate (Fig. 15A) onto the posts (Fig. 15B) of the belt mounting plate, against the
belt.
15. Install the four previously removed M6 - 1.0mm hex flange nuts (Fig. 16A) onto the belt mounting
bracket posts. Tighten the nuts to
25 ft-lbs.
16. Repeat steps 11-15 for the other three belts.
Fig. 14
Fig. 15
Fig. 16
A
B
C
A
B
A
