Rev: 05.21.18
Page 6
EuroLoft™ Bed Lift (Overhead) OEM
Stabilizer Guide Track Bracket and Roller Assembly
1. Make sure the guide track roller assembly screw (Fig. 10A) is secured tightly to the wheel bracket
(Fig. 10B).
2. Place the stabilizer guide track bracket (Fig. 11A) on the corner of the side of the bed frame that will
support the bed.
NOTE: The stabilizer guide track bracket locations may vary per bed.
3. If the frame is not already pre-drilled, use the pre-drilled holes in the stabilizer guide track bracket as a
guide. Pre-drill 5/32" holes into the top and sides of the end and side rails (Fig. 10B).
4. Secure the bracket to the bed frame holes using three of the subassembly kit's #10 -12 x 1/2" hex. head
screws.
5. Repeat steps 1- 4 for the opposite stabilizer guide track bracket.
Fig. 10
A
A
B
B
B
Fig. 11
B
C
A
Installation
Belt Mounting Brackets
1. Remove the belt mounting assembly (Fig. 12) from the subassembly kit. Unscrew the nuts (Fig. 13C)
and slide the belt plates (Fig. 13B) off the belt bracket (Fig. 13A) and set aside. Do this for all four belt
brackets.
Fig. 12
Fig. 13
B
