Progressive Turf Equipment TD 92, Operator'S Manual

Page: 28 / 73

TD92
Operator’s Manual
26
SETTING THE CUTTING HEIGHT
Ensure safety locks are properly engaged before attempting to
service mower.
Each of the three independent mower decks has its own cutting height
adjustment. Cutting height is set by adjusting number of spacers
between the castor tires and mower deck. Height adjustment is made
with the mower in the transport position.
Please note that the rear, inside corner of each wing deck is supported
by pin which must be adjusted in the same manner as the castor tires
to achieve the proper cutting height.
Spacers are provided with a 3/8” and 3/4” thickness for cutting height
adjustment from 3/4
” to 5”.
NOTE: For optimal cutting results, the mower should be set to remove
not more than 1/3 of the total grass height. This will result in
the best cutting performance while minimizing stress to the
grass.
Follow these steps to adjust the cutting height:
1) Raise the mower decks into the transport (raised) position.
Ensure the deck safety locks are properly engaged.
2) Turn the engine off on the tractor, place all controls in neutral
3) position and set the parking brake.
4) Remove retaining pin from the top of the deck tire assembly or
corner pin.
5) Remove the remove the tire assembly.
6) Adjust the number of spacers between the caster tire and mower
frame to achieve the desired cutting height.
7) Install castor tire assembly on mower deck and place extra
spacers on portion of castor assembly protruding from mower
deck.
8) Install retaining pin.
Minimum Cutting Height Maximum Cutting Height