REHATEAM s.r.l.—vicolo Negrelli
5
—
31040
Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER R2 9
SERVICE MANUAL
REAR HEIGHT
FULL CARBON SIDE PLATES
Adjustment every 1 cm.
Remove the bolt
A
on both sides of the wheelchair. The inner plate of the clamp-
support
B
and the nut will come off.
Move the frame up or down until aligning the hole of the support
B
(not visible in the
picture because it lays between the plate and the frame, but it is indicated by the
dotted rectangle) with one of those of the plate
C
.
Then insert the bolt
A
, the inner plate and the nut in its location.
When tightening this bolt, check that the inner plate of the clamp does not turn (you
can hold it with your fingers), in fact, if it turns, the clamp will not take hold of the
frame properly.
Finally tighten the bolt.
There is no need to use a spanner to hold the nut; in fact, its location on the inner
clamp will hold it.
Check/adjust the brakes.
Remember that the rear height adjustment can affect the seat inclination, so it is
necessary to check and adjust the fork angle.
The rear height adjustment can also change the point of balance (setting) of the
wheelchair.
If necessary, adjust the setting.
You will never need to modify the side guard.
Part leaning
against the plate
Inner
plate
B
A
B
C
A
Inner plate
of the clamp
B
Nut
Part of the clamp
B
leaning against the plate
