REHATEAM s.r.l.—vicolo Negrelli
5
—
31040
Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER R2 20
SERVICE MANUAL
FOOTPLATE DISTANCE
Tubes with holes
G
TUB
E
TU
BE
20 mm
fixing
A
fixing
C
Rubber adaptor for round footplate tube on elliptical tube (from 2019).
The round footplate tube needs the adaptor
F
to fit the elliptical frame tube. The adaptor’s hole is not centred, therefore, you have to pay
attention to mounting right and let adaptors in the same way.
•
If the centre of the fixing hole
A
is at 20 mm from the lower extremity of the frame tube, the adaptor
F
is usually mounted with its narrower
side facing frontward. In order to avoid squeezing the adaptor too much, do not tighten the bolt very hard.
•
If the centre of the fixing hole
A
is further than 20 mm, thus even the hole
C
, the adaptor
F
is glued to the frame and assembled with its
narrower side backward. This is due to the fact that when you tighten the bolt, the tube will lean against the inner side (which is very close)
of the frame tube and that guarantees the stability of the system. The bolt for this fixing includes a spacer
G
under the bolt’s head. This
way, the bolt will run in beyond the frame tube wall; if so, it would impede the correct fixing of the footplate tube. (This fixing is of course
also possible if the point
A
is at 20 mm).
•
To turn the adaptor, (if it is not glued), remove the footplate tube, slide the adaptor off and mount it reversed.
With elliptical footplate tubes, the adaptor is not present.
A
20 mm
B
A
Adjustment every 1.5 cm.
Remove the bolts
A
and their corresponding washers and nuts
B
.
Slide the footplate tubes to the necessary height.
Make sure the two tubes are at the same height.
Insert and tighten the bolts.
After adjustment, check that between the lower side of the footplate and the ground
there is at least 2 cm and that there is no interference between footplate and casters.
Note: the part of the frame below the fork support, according to the requested
footplate distance, can be either 65 or, if the frame is cut, 20 mm long.
In both cases, the hole for the fixing bolt has to be 20 mm from the edge of the
frame so that it will correspond to the hole of the adaptor. If the frame is not cut
at origin, you can cut it off 45 mm afterwards. The 5 mm hole at the rear side is
pre-drilled, whereas you will have to drill an 8.5 mm hole on the front side.
To drill that hole, you have to be very careful to centre it with the frame’s axis as
well as the rear hole’s axis. It is advisable to mark the reference point before
cutting the frame; put a piece of sticky paper tape on the frame and, with a pen
or pencil, and draw the precise point, 65 mm from the edge, where to drill the
hole. Now, always paying attention to the centring, drill a 3 mm hole first, then 6
mm and finally 8.5.
20
65
45
20
45 Frame
cut
REAR FRONT
