User manual Profline SFM.
© Profline
Specifications are subject to change without notice
IQD (when installed)
When selecting the submenu "IQD", the following subjects can be adjusted:
-
IQ channel 1-16
-
Data mode AI/PI Additional / Program Information (see *)
-
Mono mode Monol/Mono2
Only active when the selected channel is mono. When the selected channel is stereo this preset has
no effect on the broadcast mode.
When the channel switches to mono this mode will become active.
* Additional Information is the information witch is inserted in the IQ-stream at the transmitter side.
This information can be used for tuning-in and monitoring the channel.
* Program Information is the information which is broadcasted by the stations.
When selected PI-mode this transparent program information will be used as RDS-source.
When selecting PI-mode, make sure there is PI-info available from the transmitter!!
NAME
When selecting the submenu "NAME", the name of the program can be installed:
-
NAME 8 characters maximum
Available characters (ASCII 32
-
ASCII 125)
-
COPY Only available with IQD-option
By using the F2 or F3 key's (select) and the F4 key (confirm), the character can be appointed to a position. The cursor, within
this menu, is a horizontal bar at the bottom of the character position.
After selecting the position (F2 or F3) of the character, the confirmation (F4) will give the menu
To select a character at the cursor position (ASCII 32 - ASCII 125). With the F2 or F3 keys, the right character can be chosen.
To install this character F4 (confirm) has to be pressed.
Note: When the IQD-option is installed there is also the possibility to copy the name from the AI or PI
blocks to the program-name of the SFM. Place the flashing cursor at COPY and press F4
PRESET
When selecting the submenu "PRESET" the following choices are available:
-
SAVE AS 1 t/m 32
-
PROGRAM PRESET 1 t/m 32
-
RECALL PRESET 1 t/m 32
When the selection of "SAVE AS" is made all relevant variables can be saved to the preset number the user has selected
with F2 or F3. By pressing F4 the variables are than saved to the preset number.
When selecting "PROGRAM PRESET" and the preset number is confirmed (F4), all variables from the submenus can be
adjusted. These will be automatically saved when changing the value and pressing the F4 (enter) key.
With the function "RECALL PRESET", the user can select an installed preset number/program which becomes active when
pressing the F4 (enter) key.
It's recommended, when saving the variables from a program, to save also the name of this program (see submenu "NAME").
This gives the user, besides the preset number, an extra identification when using "RECALL PRESET' or "SAVE AS". When
stepping through the presets I to 32, also the name of the program will be visible in the display.
