14
1 input only, but the speakon cable must be custom wired as follows: at the amplifier side it must be wired 1+ for
positive terminal and 2- for the negative terminal, at the speaker side the cable must be wired as usual 1+ for positive
terminal and 1- for the negative terminal.
Always connect a loudspeaker with a minimum impedance of 8 ohm or more.
NOTE:
Use only loudspeaker cables, never signal cables, i.e. those normally used for microphones, instruments and audio
equipment in general.
14. Channel 2 SPEAKON output
Accepts a female Neutrik Speakon NL4FX connector wired in this way:
• PIN 1+ connected to POSITIVE output of Channel 2;
• PIN 1- connected to NEGATIVE output of Channel 2;
• PIN 2+ and 2- NOT connected.
This is the amplified output of the signal applied to channel 2 input if the amplifier is set in STEREO mode or the signal
applied to channel 1 input if the amplifier is set in PARALLEL mode.
Always connect a loudspeaker with a minimum impedance of 4 ohm or more.
15. Fan
Fan Air cooling vent: always keep it clear of cables or other objects.
16. AC~ SOCKET
Here’s where you plug in your mains supply cord. You should always use the mains cord supplied with the device. Be
sure that your device is turned off before you plug the mains supply cord into an electrical outlet.
