Installation
1. AC power supply connection.
To connect this unit to AC power supply please use supplied linecord.
2. GND/LIFT selector.
This switch is used to disconnect the signal ground from the mains and
chassis earth. If it is determined that the equalizer is the cause of hum
or buzz in sound system due to a ground loop, move this switch to the
“LIFT” position.
3. Input connections
There are three different types of line level input connections, inter-
connected among them:
•
XLR balanced input (IN) connector
•
6.3mm. TRS jack balanced input (IN) connector
•
RCA unbalanced input (IN) connector
4. Output
connections
There are three different types of line level output connections, inter-
connected among them:
•
XLR balanced output (OUT) connector
•
6.3mm. TRS jack balanced output (OUT) connector
•
RCA unbalanced output (OUT) connector
NOTE It’s allowed to use an input connection type together with a
different output connection type.
NOTE In order to avoid damagig the unit, please don’t simultaneously
use more than one input and one output.
Connections:
•
XLR balanced connector – wiring diagram:
