PROEL 164935, User Manual

Page: 5 / 28

5
detailed description. This warranty does not extend to damage resulting from improper installation,
misuse, neglect or abuse. Proel S.p.A. will verify damage on returned units, and when the unit has been
properly used and warranty is still valid, then the unit will be replaced or repaired. Proel S.p.A. is not
responsible for any "direct damage" or "indirect damage" caused by product defectiveness.
MAINTENANCE AND DISCLAIMER
• Clean only with dry cloth.
•
Proel products have been expressly designed for audio application, with signals in audio range (20Hz to
20kHz). Proel has no liability for damages caused in case of lack of maintenance, modifications, improper
use or improper installation non-applying safety instructions.
•
Proel S.p.A. reserves the right to change these specifications at any time without notice.
•
Proel S.p.A. declines any liability for damages to objects or persons caused by lack of maintenance,
improper use, installation not performed with safety precautions and at the state of the art.
POWER SUPPLY
•
Do not place the power adaptor and its cord near heat sources such as heaters or radiators, and do not
excessively bend or otherwise damage the cord, place heavy objects on it, or place it in a position where
anyone could walk on, trip over, or roll anything over it.
•
Before connecting the product to the mains outlet make certain that the mains line voltage matches that
shown on the name plate of the adaptor and that the AC outlet is protected by a residual current circuit
breaker, a voltage tolerance of up to ±10% is acceptable.
• If you intend to use the device in an area other than in the one you purchased, the included power
adaptor may not be compatible.
•
Use the supplied adaptor only. Using the wrong adaptor can result in damage to the device or
overheating.
•
When setting up the device, make sure that the AC outlet you are using is easily accessible. If some
trouble or malfunction occurs, immediately turn the power off and disconnect the plug from the outlet.
Even when the power is turned off, electricity is still flowing to the product at the minimum level. When
you are not using the product for a long time or before electrical storms, make sure to unplug the power
cord from the wall AC outlet to reduce the risk of electric shock or fire.
CONFORMITY
•
The product is in compliance with CE Directive LVD 2014 / 35 / CE as stated in EN 60065 standard.
•
The product is in compliance with CE Directive EMC 2014 / 30 / CE as stated in EN 55103-1 and EN
55103-2 standards.
FCC COMPLIANCE NOTICE
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from tha t to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.