Published: 18.07.2019
54 (63)
6.
Press the
Connect
button.
The indicator light is illuminated continuously when Produal MyTool
®
is connected to the device.
7.
Press the
Configure manually
button.
Back
Configurations
view has the following menus:
UI Settings
Set up display settings.
Measurement Settings
Set up measurement settings.
Transmit Settings
Set up change of value (COV) settings.
Measurement Corrections
Tune the measurement values. The menu is applicable only for devices equipped
with display.
See more information about the settings from the following chapters.
8.
Make the changes to configuration.
9.
Press
Install to device
button to write the changes to the device.
Note:
You can also save the settings to Produal MyCloud or locally to your device. Then
the settings can be uploaded to another device by using
Use existing file
function.
10.
Press the
Back
button.
11.
Press the
Back
button again to disconnect from the device.
Produal Oy | Keltakalliontie 18, FI 48770 Kotka, Finland | tel. +358 10 219 9100 | fax. +358 5 230 9210 | [email protected]
Information is subject to change without prior notice.
EN - 5401comm
