3-6 PRODIGIT
3.4.2 TEST MODE
The TEST Mode of Auto-Sequence function is entered by press S3 + S4 key
simultaneously, the S3 and S4 LED are ON to indicate Auto-sequence mode,
then the Test mode of Auto-sequence function is proceed by press START
key.
The TEST MODE flow chart is described below:
3.4.2.1 After press START key, the 3302C controls all the module within
the mainframe to recall correspond memory which had been
stored in Auto-sequence (n1~n9) memory.
3.4.2.2 The sequence start from (Step 0 - t1 - t2), then (step 1 - t1 - t2),
and so on until last step or stop by press EXIT key.
3.4.2.3 The two digit LED display will show GO (flash) if all the test in all
module is pass, and will show nG (flash) if there is at least one
failure during the test.
3.4.2.4 User can press Start key to continue another test, or the 3302C
can quit from Auto-Sequence mode by press EXIT key.
S3+S4
Show n1-n9
Start Mode
1.Press S3+S4 key, and S3 and S4 LED are ON
2.Show AUTO SEQ. No.1-No.9,
Press Up/Down key to set n1-n9
Initial = n1
Press Start key
3.Press Start key to Start Mode
Testing
1.To recall correspond memory which had been stored in n1-n9 memory
Show Memery
bank and State
EXI
Yes
End?
No
Sp = Sp+1
No
PASS/FAIL
Show GO
Show NG
PASS
FAI
1
2
3
Yes
4.1 If no than Step + 1, continue another step.
4.2 If "Yes", than if all the test in all module is pass,
Show GO.
4.3 If "Yes", than if there is at least one failure during the test,
Show NG.
4
4.2
4.3
4.1
4.If test is GO, than step is last?
3.Press Exit key to quit the AUTU SEQ mode
2.Check the GO/NG indicator
Press Exit key
Any key
Fig 3-5 TEST MODE OPERATION FLOW-CHART
